Products are listed alphabetically.

Page 1 of 2    Next page »

1. 4-PUSHBUTTON SWITCH (MODEL CM-16) 4-Pushbutton Switch is a set of four snap-action button switches housed side-by-side, each in a 0.5" diameter recess. Pressing each button activates one switch. An audible click accompanies switch activation. DIMENSIONS: 2.5 x 4.3 x 1 inches. WEIGHT: 4 ounces....[More Information]
   
   
2. 5-PUSHBUTTON SWITCH (MODEL CM-18) The 5-Pushbutton Switch, model CM-18, is a set of four snap-action button switches housed side-by-side, each in a 0.5" diameter recess, with an additional raised pushbutton on the same housing. All switches are activated by being pressed. An audible click accompanies switch activation. DIMENSIONS: 2.5 x 4.3 x 1 inches. WEIGHT: 4 ounces....[More Information]
   
   
3. AIRLINK CORDLESS SWITCH The AirLink Cordless Switch is a touch switch designed for use by individuals with upper extremity disabilities. Used without a cord, it can be used to remotely activate appliances, toys, etc. connected to the PowerLink 3 (see separate entry) from a distance of 20 feet. Using the switch with the included cord causes it to function like a Jelly Bean Switch (see separate entry) to activate connected toys, appliances, etc. The switch is contained in a high-impact disk with a connectable base, enabl...[More Information]
   
   
4. ANALOG SWITCH PAD The Analog Switch Pad is a touch activated buttonswitch designed to control battery operated toys, environmental controls and computer access interfaces. The force adjustable electronic switch features a large activation area that is soft and compliant to the touch. Force sensitivity can be adjusted by a small dial from approximately one ounce to 32 ounces activation pressure, applied over an area ranging from the size of a fingertip to the size of the entire switch surface. A small LED lamp glo...[More Information]
   
   
5. ASL 6 FUNCTION BIG BUTTON BED CONTROL (MODEL ASL706) The ASL 6 Function Big Button Bed Control, model ASL706, is a bed control designed for use by individuals with fine motor disabilities, cerebral palsy, or neurological or severe physical disabilities. This control interface for a six-function electric bed has six large push buttons. To operate, this unit interfaces with the ASL 703 Six Function Bed Control (not included; see separate entry). It allows each function to be accessed through the use of large mechanical buttons in place of the small,...[More Information]
   
   
6. ASL BUTTON SWITCH (MODEL ASL305) The ASL Button Switch, model ASL305, is a button switch designed for use by individuals with mobility, upper extremity, or severe physical disabilities or spinal cord injury. This light touch button switch has a mono port and can be used on a powered wheelchair or to control a computer or other accessory. OPTIONS: Armrest switch mounting bracket (model ASL 611)....[More Information]
   
   
7. ASL EGG SWITCH (MODEL ASL300) The ASL Egg Switch, model ASL300, is a mechanical button switch designed for use by individuals with cerebral palsy or neurological or upper extremity disabilities. This brightly- colored oval-shaped switch features a seal that prevents liquid or food spillage from entering the switch and interfering with its operation. The base of the switch has screw insets for secure mounting. Each switch comes with a colored cover and a mono port. OPTIONS: Arm rest switch mounting bracket (model ASL 611); fi...[More Information]
   
   
8. BITTY BUBBLE (MODEL 5100) The Bitty Bubble, model 5100, is a sensory integration activity designed for use by children with fine motor, cognitive, neurological, and sensory disabilities. This unit encourages finger isolation and is a single-finger center that acts as a switch and a multi-sensory activity center simultaneously. A touch of the button in the top of the dome causes an attached device to activate and lights, music, and vibration to engage. POWER: Uses two double-A batteries....[More Information]
   
   
9. BUDDY BUTTON SWITCHES Buddy Buttons are touch switches designed designed to provide computer accessibility or to activate toys and appliances for children who have physical and/or visual disabilities. These single switches are activated by pressing anywhere on the top surface: the force to activate around the edges, 3.5 ounces, almost half the force required in the center, 7.5 ounces. Two threaded inserts on the bottom of the switch to allow for secure mounting on the TASH Mighty Mount (see separate entry) or other m...[More Information]
   
   
10. BUTTON SWITCH (MODEL 680, 680-8) The Button Switch is a thumb switch designed to develop fine motor skills for individuals with physical or neurological disabilities. It is activated by pressing a button similar to a doorbell. The button is mounted on a rectangular base which is secured to smooth surfaces with suction cup feet. It comes with a standard 0.25 inch plug and jack or with 1/8 inch plug and jack. DIMENSIONS: Button measures 5/8 inch....[More Information]
    
    
11. CAMPBELL ADA COMPLIANT PEDESTRIAN PUSH BUTTONS (MODELS 200, 400, 500, 800, 900, 4 EVR 120, 1371-412, & 4960-412) Campbell ADA Compliant Pedestrian Push Buttons are audible pedestrian control switches designed for use by individuals who are blind or have low vision. Controls include a large round button in a round or rectangular mounting plate of stainless steel, aluminum, or PVC plastic. An audible tone and LED visual signal are momentarily activated when the button is pressed. Available switches include pressure sensitive solid state (model 4 EVR 120), typical movement solid state (model 700, 800, and 900...[More Information]
    
    
12. CAP SWITCH (MODEL 58060) The Cap Switch, model 58060, is a small buttonswitch designed for use by individuals with upper extremity disabilities who have good ability to target smaller surfaces. The small, round single switch is activated using nine ounces of pressure and provides auditory feedback upon activation. The rubber base prevents slipping. DIMENSIONS: 1.8 x 0.6 inches high. WEIGHT: 6 ounces....[More Information]
    
    
13. CLAMP-ON BUMP SWITCH Clamp-On Bump Switch is a button switch activated by 2 ounces of pressure on its tip. This switch is designed to be attached to a bed, chair, table, etc. and activated by any convenient part of the body. Both momentary and toggle models are available....[More Information]
    
    
14. CUP SWITCH (MODEL 58080) The Cup Switch, model 58080, is a buttonswitch designed for individuals with upper extremity disabilities who have a good ability to target smaller surfaces. This switch is similar to the Cap Switch (see separate entry), but more durable because the switch is encased in a plastic cup. Colored stickers for the target area are included for individuals with low vision. The base provides a surface for mounting on a table, pillow, or wheelchair bracket. The switch is activated using nine ounces of fo...[More Information]
    
    
15. DUAL PUSHBUTTON SWITCH (MODEL CM-13) The Dual Pushbutton Switch is a pair of snap-action button switches housed side-by-side, each in a 1.25-inch diameter recess. Switches are activated by pressing. An audible click is provided when the switch is activated. DIMENSIONS: 2.5 x 4.3 x 1 inches. WEIGHT: 4 ounces....[More Information]
    
    
16. FINGER ISOLATION BUTTON (MODEL 716) The Finger Isolation Button is a buttonswitch and fine motor skills training device designed for use by children with fine motor disabilities. This recessed button encourages isolated touch and is designed to help a child gain the motor skills necessary for mastering computer keyboards. DIMENSIONS (LxW): 3 x 1.5 inches. COLOR: Yellow....[More Information]
    
    
17. GIMPGEAR ROUGHNECK DUAL PUSHBUTTON SWITCHES RoughNeck Dual Pushbutton Switches are touch switches designed for use by individuals with upper extremity disabilities. These feather-touch switches provide auditory feedback, allowing users without sensation in their hands to hear successful activation. The switches are rugged and can be used on wheelchair armrests and other demanding applications. The switches are compact enough to imbed into wheelchair armrest foam. DIMENSIONS: 2.3 x 1.38 x 0.8 inches....[More Information]
    
    
18. GIMPGEAR ROUGHNECK SINGLE BUTTON SWITCH The GimpGear RoughNeck Single Pushbutton Switch is a buttonswitch designed for use by individuals with severe physical or neurological disabilities or spinal cord injury. This feather-touch switch provides auditory feedback, which allows users without sensation in their hands to hear successful activation. The switch is rugged for use on wheelchair armrests and other demanding locations, and can be imbedded into wheelchair armrest foam. It can also be used as a head switch when properly mounted....[More Information]
    
    
19. HEADSWITCH (MODEL 705) The Head Switch is a touch switch that can activated with various body parts for individuals with physical disabilities. The switch requires very little pressure and so can be used by the head, knee, elbow, cheek, etc. Contact manufacturer for information on switch mounting kits (not included). DIMENSIONS: The length is 3.75 inches....[More Information]
    
    
20. IPAD CORDLESS SUPER-SWITCH The iPad Cordless Super-Switch is a touch switch designed to enable individuals with severe physical, motor control, or upper extremity disabilities, neurological or spinal cord injury to control an Apple iPad. The circular switch connects to the iPad wirelessly using Bluetooth 2.1 and has a range of over 50 feet. It can be activated by pressing anywhere on the large top surface. COMPATIBILITY: For use with the Apple iPad. DIMENSIONS: The diameter of the switch is 5 inches. POWER: Rechargable li...[More Information]
    
    
21. JELLY BEAN SWITCH The Jelly Bean Switch is a button or touch switch designed to control a wide range of electrically- or battery-operated devices and toys for people with upper extremity disabilities. The switch is contained in a high-impact disk and the entire surface of the switch is sensitive to pressure, requiring less than two ounces of pressure for activation. The Jelly Bean Switch can be mounted on any surface using readily available adhesives or they can be mounted on AbleNet's Slim Armstrong (see separat...[More Information]
    
    
22. JOYSTICK (MODEL 720) The Joystick, model 720, is a joystick designed to act as a four way switch for individuals who have physical disabilities. It has a cylindrical handle with a thin base and activates four different devices depending on the direction that the switch is moved (up, down, right or left). It can be used for teaching directionality as well as other spatial relationships. DIMENSIONS (HxLxW): 4.5 x 7 x 6.25 inches....[More Information]
    
    
23. LIGHT LOCATOR SWITCH (MODEL 7770) The Light Locator Switch (LLS), model 7770, is a buttonswitch designed for use by individuals with severe physical or upper extremity disabilities and low vision. This switch provides both a visual and a tactile cue. The red locator light guides the user to the switch. When the switch is pressed, the user feels vibrotactile stimulation and sees multi-colored blinking lights, all while activating any toy or device. POWER: Uses 2 double-A batteries. DIMENSIONS (LxWxH): 5 x 4 x 2 inches....[More Information]
    
    
24. LIGHTED SIGNAL SWITCH (MODEL 956) The Lighted Signal Switch, model 956, is a button switch and visual stimulation activity designed for use by children with cognitive, upper extremity, or severe physical disabilities. When this textured signal switch is activated, a bright light shines to encourage visual attention. POWER: Uses 2 double-A batteries. DIMENSIONS (HxD): 4 x 6.5 inches....[More Information]
    
    
25. LIGHTED VIBRATING CONE (MODEL 6100) The Lighted Vibrating Cone, model 6100, is a sensory integration activity and buttonswitch designed for use with children with upper extremity disabilities, cognitive, sensory, or neurological disabilities. Mounted on a conical base, touching the center of the button causes the unit to light and vibrate, providing multisensory stimulation. The unit can also activate any attached, switch-activated toy or appliance....[More Information]
    
    

Page 1 of 2    Next page »